Necromunda STLs for enforcer automata weapons mount

[BubbaPigskin]

So the Enforcer 'Sanctioner' Pattern Automata kit comes with five different weapons per robot sprue, and they have a standardized mount to attach to the Automata. And of course, in typical GW fashion, there are pieces for two mounts per sprue. So if one wants to build all the weapons and be able to swap them out, you can't because you only have pieces for two mounts.

Any thoughts on where I could find or commission an STL of pieces 18 & 19 from the sprue so I can get full use of the kit?

 

[Pagumb]

No good ideas myself. I've never commissioned bits from any of the sculptors or 3rd party bits sellers. Nothing pops up when I search Etsy for 'sanctioner' bits and I can't even find a good image of those bits to see if a vendor may have something that's close enough without commissioning something. Hope you're able to find something that will work one way or the other.

Your post was a good reminder that I pre-ordered a box of Sanctioners from my local hobby shop almost two months ago and they still haven't arrived. Must be stuck in the GW pipeline. Update from FLGS: They yet to receive of that model from GW...stuck in the pipeline.

 

[Spearhavok]

I myself modified the lower portion (the 'elbow'?)
Trimmed some of the ridge off the upper 'donut' bit so it could slide into the gap on the weapons, and then cut the centre nubs out of the weapons (the concussion cannon needed some extra trimming as the gap is smaller than the donut)
Haven't painted anything yet but so far it seems to be working okay. May need to tuck a tiny magnet or something in there before I'm done; we'll see...

 

[Stormtrooper74]

If you use 2×1mm magnets (2 on weapon side and 1 on cap side) you can swap all the weapons thru elbow circle joint.